View of the mount

Sketch of the mount

Signal Signal LP42-22DT E93113 mount has been designed to place a modern LCD/LED/OLED television/monitor on a wall. Its load capacity is 50 kg. The mount allows easy adjustment of tilt (without additional tools) in the range of -10 to +5 degrees.

The mount cannot be installed on walls that do not provide firm hold (steel stud, old cinder block, plaster panel etc). If you are uncertain about the nature of the wall, consult an installation company.

The set contains all components needed for typical installation. In some specific conditions there may be required auxiliary elements or tools that should be supplied by professionals installing this type of hardware.

The basic tools required (not included): 3 mm drill bit for mounting on wood / metal constructions, 10 mm masonry bit for brick / concrete block installations, electric drill, Phillips screwdriver (min. length: 200 mm), marker.

The set includes assembly instructions. If you do not understand those directions, or have any doubts about the safety of the installation, please call a qualified installer.

Before mounting check carefully to make sure there are no missing or defective parts. If you have any doubts do not begin installation.

Improper installation may cause damage or serious injury.

Do not use this product for any other purpose than specified.
Neither the producer nor distributor shall be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.