View of the camera

Bottom view

Rear view

The included accessories

View of the packaging

Megapixel camera ULTICAM DS-2CD852F has been equipped with 1/3" CMOS sensor. It ensures 1600x1200 (UXGA) resolution and sensitivity of 2 lx. The camera cooperates with fixed lens (without AI) with C/CS mounts.

ULTICAM DS-2CD852F utilizes MPEG-4 compression. The images can be forwarded with UXGA resolution at 5 fps, or with VGA (or lower) resolution at 25 fps.

Every ULTICAM camera includes "Net Video Application Software" - "ULTIMAX Client" - advanced NVR application enabling the user to manage all ULTISYSTEM devices.

The camera allows to define 15 levels of access rights.

Aside from resolution and frame rate, the user can set:

• image quality,
• kind of frame,
• type of stream,
• bitrate parameters,
• repeatability of "I" frames,
• maximum bitrate - apart from the predefined values there can be set any speed, up to 8 Mbps

Configuration of the camera is possible via Internet browser or with the included ULTIMAX Client software.

The camera has been equipped with the following connectors/interfaces:

• 2 x JACK (audio in / audio out)
• RS485 - terminal block
• two alarm connectors (in/out) - terminal block
• RJ45 socket (Ethernet)
• SD flash memory card slot
• grounding connector.

The camera can cooperate with Pan-Tilt devices that are controlled through the RS485 interface. There are over 80 PTZ protocols available. The built-in hardware motion detection enables the operator to define monitored areas and sensitivity.

Any alarm can generate:

• OSD info
• alarm sound
• action of alarm output

The camera:

• is based on RTOS Linux,
• provides TCP/IP, UDP, RTP, Multicast, PPPoE protocols,
• utilizes NAS technology - direct streaming to Network Attached Storage.